Check out all the cool stuff in our
REVERB STORE
CLICK HERE

Hello...

It looks like you are visiting our site on a browser that is really old. Unfortunately, this means you can't get the full experience. It'd be awesome if you could upgrade to a modern browser, especially Chrome and Firefox as that is the best out there right now.

Copyright 2014. All Rights Reserved.

    Resistor-Based Models

    Resistor-Based Models
    Show
    Set Descending Direction

    Impedance selector for 4, 8, 16 ohms, treble compensation switch, Bypass switch, Line Out. Employs a resistive load like other attenuators on the market. Not as interactive as the MASS products. The attenuation is continuously adjustable from -3dN to over -50db. As with all Weber attenuator products, by turning the speaker control to minimum (maximum attenuation), the unit may be used as a dummy load for testing or for DI use.

    This item is hand-built to order, to ensure the best attention to detail is paid to its construction.  We build them one at a time, on a table - not hundreds at a time on an assembly line.  This allows us to reduce the margin for error and produce an overall higher-quality product.  Please allow at least 7-10 business days for your order to be built and then shipped.

    Full attenuation: up to 35w amplifiers. Slight attenuation: up to 50w amplifiers.

    This device is a 50 watt dummy load with a headphone output jack.The headphone jack is a stereo jack wired for mono operation. The output level to the headphones is continuously adjustable. A variable line out is also provided. The load switch switches between the normal speaker for the amplifier and the internal dummy load, which is nominally 8 ohms. Most amplifiers will tolerate a 2 to 1 impedance mismatch. The headphone output jack and its volume control are always active regardless of the position of the load switch.

    This item is hand-built to order, to ensure the best attention to detail is paid to its construction.  We build them one at a time, on a table - not hundreds at a time on an assembly line.  This allows us to reduce the margin for error and produce an overall higher-quality product.  Please allow at least 7-10 business days for your order to be built and then shipped.

    For use with up to 50w amplifiers

    20 watt dummy load. This device is inserted inline with one or more speakers in a multi speaker cabinet. The purpose is to be able to turn off those speakers for lower volume from the amp, while retaining the proper impedance match to the amplifier.

    These are not attenuators with volume controls. They are simple on/off devices that are designed with something like a Tweed Bassman or Super Reverb in mind - where you have four 8-ohm speakers and you can put one silencer inline with each speaker you want to be able to turn off.

    Use in-line or in place of one 20w speaker

    Resistor-Based Models
    Show
    Set Descending Direction